Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Powertrain Management > Fuel Delivery and Air Induction > Fuel Injector > Component Information > Service and Repair > Two Piece Intake Manifold > Page 3518

Page 2
background image

‹› Replace

‹› Tighten the fuel rail uniformly, starting from the inside and working toward the outside

2

Fuel Rail

‹› For cylinders 1, 3 and 5.

‹› Fuel injector springs - item 11 - must be replaced before installing.

‹› Tighten uniformly, starting from the inside and working toward the outside.

3

Spring Type Clip

4

Low Fuel Pressure Sensor (G410)

‹› 15 Nm

5

Fuel Supply Line

‹› From the fuel tank.

‹› With an exception for the fuel pressure sensor (G247).

6

Bolt

‹› 8 Nm

7

Bolt

‹› 8 Nm

8

Bracket

‹› For the fuel supply line.

9

O-ring

‹› Replace

‹› Before installing, lubricate with clean engine oil.

10

Support Washer

‹› Replace if damaged, refer to => [ Fuel Injector Teflon Seal and Washer ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service

and Repair/One Piece Intake Manifold.

11

Spring

‹› Replace for every removal of the fuel rail.

‹› Ensure the spring is securely seated.

12

Cylinder 1 Fuel Injector (N30)

‹› Cylinder 3 fuel injector (N32).

‹› Cylinder 5 fuel injector (N83).

‹› Removing and installing, refer to => [ Fuel Injectors ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/One

Piece Intake Manifold.

‹› The long fuel injectors for cylinders 1, 3 and 5 must not be separated.

13

Seal

Powertrain Management > Fuel Delivery and Air Induction > Fuel Injector > Component Information > Service and Repair > Two Piece Intake Manifold > Page 3518

[PREV PAGE] [NEXT PAGE]