Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5229
Wire Break with Single Repair Point
Repair point with single crimp connection
Free up wire intended for repair (approximately 20 cm to both sides of repair point).
If required, remove wiring harness wrapping using a folding knife.
Cut out the damaged wire section using wire stripper (VAS 1978/3).
‹› If, by cutting out the damaged wire section, both ends of the vehicle-specific single wire are too short for a repair using a single crimp connection,
insert a repair wire section of matching length with two crimp connections, refer to => [ Wire Break with Dual Repair Point ] See: Wire Break
Strip wire ends using 6 - 7 mm wire stripper.
|[PREV PAGE] [NEXT PAGE]|