Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5230

Page 13
background image

-

Slide crimp connection onto both stripped wire ends of vehicle-specific single wire and crimp them using crimp pliers.

‹› Always be sure to use the correct crimping slot for the crimping connection used. Refer to => [ Crimping Pliers with Insert ] See: Description and

Operation/Crimping Pliers With Insert.

‹› Do not crimp wire insulation.

After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.

-

Put Shrink tip for hot air gun (VAS 1978/15) onto Hot air gun, 220 V/ 50 Hz (VAS 1978/14).

-

Heat crimp connection using hot air gun lengthwise from center outward until it is sealed completely and adhesive comes out the ends.

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5230

[PREV PAGE] [NEXT PAGE]