Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Steering and Suspension > Alignment > System Information > Service and Repair > Wheel Alignment Test Prerequisites > Page 5634
=> [ Adaptive Cruise Control, Calibration Information ]
=> [ Adaptive Cruise Control, Calibrating during Vehicle Alignment ]
=> [ Adaptive Cruise Control, Calibration without Prior Vehicle Alignment ]
Adaptive Cruise Control, Calibration Information
When must it be calibrated?
It must be calibrated if:
‹› The lock carrier was removed and installed.
‹› The adaptive cruise control (ACC) sensor (G550) was removed and installed.
‹› If toe and/or rear axle camber was adjusted during a vehicle alignment.
What test requirements must be fulfilled for calibration?
‹› Previously performed vehicle alignment or wheel run-out compensation.
‹› Specified values for tire pressure and height are checked.
Adaptive Cruise Control, Calibrating during Vehicle Alignment
Observe the following work sequence!
Observe the notes in your alignment unit. Refer to => [ Adaptive Cruise Control, Calibration Information ].
|[PREV PAGE] [NEXT PAGE]|