Passat Sedan V6-3.6L (BLV) (2008)
/Page-1647014.png)
Further installation is in the reverse sequence to removal.
After the installation the vehicle must be measured.
-
Perform vehicle alignment. Refer to => [ Wheel Alignment Overview ] See: Alignment/Service and Repair/Wheel Alignment Overview.
-
The boots have been exchanged, then perform a basic setting for the steering angle sensor (G85) via Guided Fault Finding using (VAS 5051B).
-
Then perform basic setting of steering system via Guided Fault Finding using (VAS 5051B).
Tightening Specifications
