Passat Sedan V6-3.6L (BLV) (2008)
-
Remove bolts - arrows A - from heat shield.
-
Remove bolt - arrow B - and slide exhaust pipe of auxiliary heater - 1 - upward.
Continuation for All Vehicles
-
Disconnect the connector from the oil level thermal sensor (G266) and disconnect the wire on the subframe.
-
Remove bracket for exhaust system from the subframe.
-
Remove coupling rods from stabilizer.
-
Remove nuts - arrows -.
-
Loosen nut of track rod ball joint, but do not unscrew yet.
‹› To protect thread, screw nut on pin a few turns.
-
Press off tie rod end from wheel bearing housing with (3287A) and then remove nut.