Passat Sedan V6-3.6L (BLV) (2008)
-
Tighten bolt - arrow - for tie rod - 3 -.
‹› Make sure that washer is installed between nut and wheel bearing housing.
-
Insert coupling rod - 2 - into stabilizer and tighten nut - 1 -.
-
Install coil spring. Refer to => [ Coil Spring ]. See: Service and Repair/Removal and Replacement/Rear Suspension/Front Wheel Drive
(FWD)/Removal and Installation/Coil Spring
-
Install wheel and tighten. Refer to => [ Tightening Specification for Mounting Wheels ] See: Wheels and Tires/Wheel
Fastener/Specifications/Tightening Specification For Mounting Wheels.
-
Perform vehicle alignment. Refer to => [ Wheel Alignment Overview ] See: Alignment/Service and Repair/Wheel Alignment Overview.
Tightening Specifications