Passat Sedan V6-3.6L (BLV) (2008)
-
Remove the oil pan together with the gasket.
Installing
Installation is performed in the reverse order of removal. Pay attention to the following:
-
Clean the two magnets in the oil pan depressions. Ensure that the magnets are in full contact with the oil pan.
-
Check the gasket for damage and make sure all of the spacers (quantity: 8) are present.
Otherwise, replace the gasket.
-
Install the oil pan and gasket; when doing this be sure not to pinch any wires.
-
Make sure the oil pan gasket is properly seated.
-
Tighten the oil pan bolts - arrows - in stages and in a diagonal sequence. Refer to => [ Fastener Tightening Specifications ] See: Valve
Body/Specifications/Fastener Tightening Specifications - Gears, Hydraulic Controls.