Passat Syncro Wagon V6-2.8L (ATQ) (2000)
4. Clamp
^
Always replace
5. Multi-point socket head bolt
^
40 Nm (30 ft. lbs.)
^
M8x48
6. Plate
7. Protective boot for inner constant velocity joint
^
Check for tears and chafing
^
Drive off with drift
^
Before installing on constant velocity joint, coat sealing surface with D-3
8. Dished washer
^
Not applicable
9. Inner constant velocity joint
^ Only replace complete
^
Pressing off refer to Fig. 2
^
Pressing on refer to Fig. 3
10. Gasket
^
Replacing: pull off protective foil and stick onto joint.
11. Circlip
^
Always replace
^
Remove and install with VW 161a
12. Drive shaft
13. Dished washer
^ Outer diameter (concave side) contacts thrust washer
14. Thrust washer
15. Circlip
^
Always replace
^
Insert in shaft groove
Fig. 1 Pressing off outer constant velocity joint
-
Clamp drive axle in vise using protective jaw covers.
-
Remove clamp and slide back boot.
-
Install M14 threaded section into joint until constant velocity joint is pressed off drive axle.
Fig. 2 Pressing off inner constant velocity joint
Note:
^
First drive off boot with a drift
^
Support the ball hub