Passat Wagon L4-1781cc 1.8L Turbo (AEB) (1998)
-
Drive shaft with threaded hole upward.
-
Secure shaft in by penning transmission housing to shaft using a center punch -A-.
Fig. 3 Selector shaft, removing and installing
-
Remove bolt (arrow) and take out lock washer.
^
Lock washer is placed in groove of selector shaft and keeps shaft from falling out.
^ Selector shaft can be removed or installed after removing detent spring -A-.
Fig. 4 Detent spring, installing bolts
-
Install bolts -1- and -2- approx. 3 turns.
-
Tighten bolt -2- to 10 Nm (7 ft. lbs.) and then tighten bolt -1- to 10 Nm (7 ft. lbs.).
Fig. 5 Transmission/final drive breather, removing and installing
1. Breather cap
2. Breather
3. Breather line
Remove using pliers
Drive in with copper drift