Passat Wagon L4-1781cc 1.8L Turbo (AEB) (1998)
Wiring For Selector Lever Lock, Selector Lever Illumination And Tiptronic, Removing And Installing
Removing
-
Remove center console and extension.
-
Disconnect connector -1- for selector lever lock solenoid -2- (concealed).
-
Unclip cover -3- and lift up.
-
Pull out connector -4- for gearshift positions and Tiptronic in direction of arrow.
-
Disconnect wiring at connector -5-.
Installing
Installation is performed in the reverse sequence.
Selector Lever Handle, Removing And Installing
Removing
-
Shift selector lever into position "2".
-
Slide sleeve -1- down as far as it will go.
-
Carefully pull button -2- out of selector lever handle -3- over the detent point until dimension "a" is obtained. Lever -4- will then be pulled out of
rod -5-.
Dimension "a" = 5 mm (0.19 inch)
-
Dimension "a" corresponds to width of connecting eye -6- on spring -7-.
Do not stretch or forcibly remove the spring
-
Simultaneously pull handle -3- off selector lever -8-.
Installing
-
Shift selector lever into position "2"