Passat Wagon L4-2.0L Turbo (BPY) (2008)
-
Press the mount into the notch on the clutch pedal - 3 - until it engages audibly.
-
Install the over center spring - 2 - from above into the mounting bracket and hold the spring end in the installed position using the (T10178) while
doing so.
-
Insert the clutch pedal pivot - 1 - into the over center spring - 2 -.
-
Press on clutch pedal slightly, push the bolt through and tighten the self locking nut.
-
Install the mounting bracket. Refer to one of the following:
Eos, refer to => [ Mounting Bracket ]. See: Clutch Hydraulic System/Service and Repair/Removal and Replacement/Clutch Pedal and
Hydraulics/Mounting Bracket
Passat, Passat CC and CC, refer to => [ Mounting Bracket ]. See: Clutch Hydraulic System/Service and Repair/Removal and Replacement/Clutch
Pedal and Hydraulics/Mounting Bracket
Tightening Specifications