Polo Mk3
| Dismantling and assembling heater unit |
| 1 - | Heat exchanger |
| q | To renew: remove heater unit → Chapter. |
| q | After removal, completely renew coolant. |
| 2 - | Self-tapping fillister head screw |
| 3 - | Air distribution housing |
| q | Do not dismantle further. |
| 4 - | Fresh air and air recirculation flap control motor -V154- |
| q | Installing → Chapter. |
| 5 - | Self-tapping fillister head screw |
| 6 - | Fresh air blower -V2- |
| q | Removing → Chapter. |
| 7 - | Fresh air blower series resistor with overheating fuse -N24- |
| q | Removing → Chapter. |
| 8 - | Self-tapping fillister head screw |
| 9 - | Central flap lever |
| q | Installing and adjusting → Chapter. |
| 10 - | Temperature flap lever |
| q | Observe correct spare part number. |
| 11 - | Base plate |
| 12 - | Heat exchanger/bulkhead seal |
| q | Note installation position → Chapter. |