Volkswagen Workshop Service and Repair Manuals

• Selector lever handle
• ◆ Removing and installing =>from page 37-61
• Sleeve
• Frame
• Cover
• Gasket
• Bolt
• Selector lever housing
• ◆ Separating selector lever from selector lever housing=> Fig. 2
• Pin
• Pin
• Selector lever
• Cover plate

• Screw, 25 Nm
• ◆ Qty. 4
• Nut, 15 Nm
• ◆ Qty. 3
• ◆ Always renew
• Selector lever lock solenoid -N110-
• ◆ Tested in the vehicle by self-diagnosis

=> Self-diagnosis for automatic gearbox 001; Repair group 01; Performing self-diagnosis; Reading measured value block

• ◆ Installing => Fig.1

• Circlip
• ◆ Always renew
• Nut, 15 Nm
• ◆ Always renew
• Bush
• Bracket
• ◆ Secures selector lever cable to sub-frame

• Hexagon bolt, 6 Nm
• Bracket
• ◆ To secure selector lever cable in engine compartment
• Hexagon bolt, 6 Nm
• Selector lever cable
• ◆ To remove, remove catalyst and forward protective plate.
• ◆ Do not bend or kink, lightly grease cable eye and cable ends before installing.
• ◆ Checking and adjusting on vehicles from 07.99
• Locking cable
• ◆ Must not be kinked
• ◆ Adjusting on vehicles from 07.99
• ◆ Removing and installing => Page 37-23

→ Fig.1     Removing and installing solenoid -N110-

• ‒ Insert solenoid pull rod -arrow- in rectangular aperture of locking lever.

→ Fig.2     Separating selector lever from selector lever housing

The selector lever is engaged in the selector lever housing twice on each side.

• ‒ Carefully release the locking tabs on both sides.