Volkswagen Workshop Service and Repair Manuals

• ◆ The pinion shaft with parking lock gear and the valve chest must be removed to dismantle and assemble the parking lock.
• ◆ Adjusting multi-function switch .

• Seal
• ◆ For selector shaft
• ◆ Removing => Fig.1
• ◆ Knocking in => Fig.2
• Selector shaft
• ◆ Removing and installing => Fig. 3
• ◆ Prevent axial impact on the selector shaft when transporting the gearbox as the bolt -item 3 - could shear
• Bolt, 10 Nm
• ◆ Locks the selector shaft in the gearbox housing

• Spring for selector segment
• ◆ Do not bend
• Bolt, 5 Nm
• Selector segment
• Spring pin
• ◆ For selector segment
• ◆ Drive out with drift
• ◆ Drive in after fitting selector segment => Fig.3
• Spring pin
• ◆ For lever -item 9 -
• ◆ Drive out with drift
• ◆ Drive in after fitting selector segment => Fig.3
• Lever
• ◆ Assemble with engaging lever -item10 - before fitting on selector shaft

• Engaging lever
• ◆ Fit on selector shaft together with lever
• Bolt, 10 Nm
• Supporting plate
• ◆ For engaging lever
• Bolt, 5 Nm
• Cover plate
• ◆ Secures detent lever shaft
• Shaft for detent lever
• ◆ Can be removed and installed by hand
• Return spring
• ◆ Removing and installing => Fig. 4
• Detent lever
• ◆ Removing and installing => Fig. 4

→ Fig.1     Removing selector shaft seal

→ Fig.2     Installing selector shaft seal

• ‒ Fill space between seal and dust lips of new seal with multi-purpose grease.
• ‒ Drive seal in onto stop using either T30030 or press piece 3401.

→ Fig.3     Driving the spring pins -1- out and in

Driving out

• ‒ Only drive spring pins for lever -4- and selector segment -5- out as far as is necessary to remove the selector shaft -2-.

Driving in

• ‒ Drive spring pins in flush after fitting the selector shaft in selector segment and lever.
• ‒ Lock selector lever with bolt -3-.

→ Fig.4     Inserting detent lever with return spring

• ‒ Remove bolt -arrow-.
• ‒ Take off cover plate -1- and pull out shaft for detent lever.
• ‒ Remove return spring -2- and detent lever.

When installing, hook end of the return spring on detent lever with the other end of the spring contacting the gearbox housing.