Volkswagen Workshop Service and Repair Manuals

• 25 Nm
• Belt pulley
• 10 Nm
• Coolant pump
• ◆ Check for ease of movement
• O-ring
• ◆ Renew
• 25 Nm
• ◆ Do not tighten until the injection pump is bolted tightly to the console
• ◆ Note tightening sequence
  Page => 19-11 , Fig. 1

• Compact bracket
• ◆ For coolant pump, coolant thermostat, ribbed belt tensioning roller, alternator and P.A.S. vane pump
• 25 Nm
• ◆ Note tightening sequence
  Page => 19-11 , Fig. 1
• Coolant thermostat
• ◆ Checking: heat-up thermostat in water
• ◆ Opening commences approx. 85 °C
• ◆ Ends approx. 105 °C
• ◆ Opening lift min. 7 mm
• Connection

→ Fig. 1     Tightening sequence compact bracket to cylinder block

•      1 -     Guide bracket into fitted hole -1-
•      2 -     Tighten bolt -2-, 25 Nm
•      3 -     Tighten bolt -3-, 25 Nm
•      4 -     Tighten bolt -4-, 25 Nm
•      5 -     Tighten bolt -5-, 25 Nm
•      6 -     Tighten bolt -6-, 25 Nm (injection pump must be tightly bolted to console)