–
| Apply the adhesive around the border at a straight angle to the window. |
WARNING The glass must be placed within 10 minutes, otherwise, the glass adhesive adherence will be impaired |
|
t
| Place the glass in the glass gap with the help of two suction pad grippers -VAG 1344-, centralize and press until the distancing shoulder leans on the gap. |
t
| During the drying time, fasten the windscreen with the glass adjustment shim -443 845 631 A-. |
t
| Install the lower windscreen covering → Chapter. |
t
| Place eventual existing self-adhesive labels again (for example, from the airbag). |
t
| Insert the rear window wiper motor axle sealing rubber in the rear window. |
t
| Rear window clearance dimensions → Chapter. |
t
| The activator cannot be applied to the glass demister filaments. |
t
| To apply the adhesive coat, marks are placed on the left and right sides of the rear window. |
t
| After the assembly, the rear window sides can never protrude in relation to the rear door contour |
t
| During the drying time, fasten the rear window with adhesive tape. |
t
| If the adhesive cord has been applied with an excessively thick coat, and the adhesive invades the window demister area, remove the adhesive. |
|
|
|