volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
ABS Bosch 8.0 > < Install the command device to the hydraulic unit

Polo Mk4

Brake pressure sensor 1G201
Brake pressure sensor 1 -G201-
Remove
Depending on engine version, remove the air filter or the engine cover:
t  3 cylinders, injection engine → Anchor
t  4 cylinders, injection engine → Anchor
t  3-cylinder diesel engine → Anchor
t  4-cylinder diesel engine with injector pump unit → Anchor
t  4 cylinders, diesel engine with distribution injector pump → Anchor
Continuation for all vehicles:
   
–  Disconnect the connector -3- of braking pressure sensor -2-.
–  Put an adequate number of lint-free cloths under the command unit and the hydraulic unit.
–  Disconnect the brake pipes -1- from the hydraulic unit.
–  Close the brake pipes and threaded holes with plugs from the repair set number 1H0 698 311 A.
–  Remove the braking pressure sensor.
Install
–  Installation is performed in the reverse sequence of the removal.
  N45-0326
Tightening torque: 
Braking pressure sensor20 Nm

–  Bleed the brake system → Chapter
   

ABS Bosch 8.0 > < Install the command device to the hydraulic unit