WARNING The fuel system is under pressure. Before loosening hose connections
or opening checking junction, place a cloth around them. Then, eliminate
the pressure, by carefully removing the hose and loosening the closing
screw. |
|
To avoid personal injuries and/or injection and ignition system
damage, observe the following: |
t
| For safety reasons, fuse 41 must be removed from the fuse holder
before opening the fuel system. |
t
| Do not touch or remove the ignition cables while the engine
is running or when the engine is starting. |
t
| Only connect or disconnect the injection and ignition system
cables (and measuring device cables) with the ignition switched off. |
WARNING Remember the following when performing installation work,
especially inside the engine compartment where there is little space: |
t
| All hoses (e.g. fuel, hydraulics, activated charcoal filter
system, cooling system and refrigerant, brake fluid, vacuum) and electric
cables must be restored to their original positions. |
t
| Allow easy access to all the moving or hot parts. |
|
If during a test run it is necessary to use testing and measuring
equipment, observe the following: |
t
| always install test and measuring equipment on the rear seat
to be operated by someone seating there. |
If test and measuring equipment are operated from the passenger
seat, the person seated there may be injured should the airbag activate
in case of accident. |
t
| If the engine is to be turned over at starting speed, without
starting: |
|
|
|