Polo Mk5
| Adjusting glass panel (height adjustment) |
| Carry out following work: |
| – | Loosen securing bolts for glass panel. |
| – | Operate glass panel of panorama tilting roof so that it moves to „open“ position. |
| – | Operate glass panel of panorama tilting roof so that it moves to „closed“ position. |
| – | Adjust height of glass panel at front and rear on both sides as follows: |
| Front panel adjustment: |
| -Dimension a- = 1 mm lower than roof assembly frame -3-. |
| – | Press the inner seal to one side. |
| – | Tighten the front inside bolts (5.5 Nm). |
| Rear panel adjustment: |
| -Dimension b- = 1 mm higher than roof member -2- |
| – | Tighten the rear inside bolts (5.5 Nm). |
| – | Open glass panel and tighten the rear bolts (5.5 Nm). |
Note| t | To achieve the best possible optical appearance, ensure that adjustments on left and right are uniform (symmetrical). |
| t | The glass panel should not be higher than the roof at any point at the front or lower than the roof at any point at the rear. |