Polo Mk5
| Assembly overview - wheel bearings |
| 1 - | Drive shaft |
| 2 - | Suspension strut |
| q | Removing and installing → Chapter. |
| q | Repairing → Chapter. |
| 3 - | Nut |
| q | 60 Nm and turn 90° further. |
| q | Always renew after removing. |
| 4 - | Multi-point socket head bolt |
| q | Tip of bolt must point in direction of travel |
| 5 - | Hexagon socket head bolt |
| q | 8 Nm |
| 6 - | Speed sensor |
| q | Before inserting sensor, clean inner surface of hole and coat with lubricating paste -G 000 650-. |
| 7 - | Nut |
| q | 20 Nm and turn 90° further. |
| q | Always renew after removing. |
| 8 - | Bolt |
| q | 12 Nm |
| 9 - | Splash plate |
| 10 - | Track rod ball joint |
| 11 - | 12-point nut (self-locking) |
| q | 50 Nm and turn 45° further. |
| q | Always renew after removing. |
| 12 - | Bolt |
| q | 4 Nm |
| 13 - | Internally ventilated brake disc |
| 14 - | Wheel hub with wheel bearing |
| q | The ABS sensor ring is installed in the wheel hub |
| q | Different versions for 14" and 15" running gear. |
| q | Allocation → Electronic parts catalogue “ETKA”. |
| q | Pulling out → Chapter. |
| q | Drawing in → . |
| q | Always renew; is destroyed when pulled out. |
| 15 - | Wheel bearing housing |
| q | For brake caliper FN3. |
| q | For vehicles with 15” running gear. |
| q | Removing and installing → Chapter. |
| q | Allocation → Electronic parts catalogue “ETKA”. |
| 16 - | Wheel bearing housing |
| q | For brake caliper FS III. |
| q | For vehicles with 14” running gear. |
| q | Removing and installing → Chapter. |
| q | Allocation → Electronic parts catalogue “ETKA”. |