R32 4Motion V6-3.2L (CBRA) (2008)
Rear Door Latch: Service and Repair
Door Lock
Door Lock
NOTE: Removing and installing is described only for the right door lock. Removing and installing the left door lock is similar
Removing
-
Remove outer door panel
-
Remove mounting bracket
-
Disconnect harness connector - 4 -.
-
Remove the bolts - 6 -.
-
Disengage cable - 3 - from actuator lever - 5 - and remove door lock - 1 -.
Cover - 2 - is not supplied with delivery casing of door lock.
Installing
To install, perform the steps used for removal in reverse order.
Tightening torques for bolts: 18 Nm
-
Then a function test must be performed with door open, since the door cannot be opened if release is not correctly adjustment or clipped in.
