Rabbit L5-2.5L (BGP) (2006)
-
Connect harness connector - 2 - to accelerator pedal module - 5 - and slide rubber grommet -1 - again on to harness connector.
-
Press accelerator pedal module on to securing studs - 6 -.
-
Insert centering pin - 7 - into hole on vehicle floor.
-
Secure accelerator pedal module with bolt - 3 - and install cover cap - 4 -.
-
Reinstall steering column cover.
-
If accelerator pedal module was replaced, adapt accelerator pedal module to Engine Control Module (ECM) Vehicle Diagnosis, Testing and
Information System VAS 5051 "Guided Functions".
-
If accelerator pedal module was replaced in vehicles with automatic transmission or Direct Shift Transmission, kick-down function must be
learned Vehicle Diagnosis, Testing and Information System VAS 5051 "Guided Functions".
Tightening torque:
Component
Nm
Accelerator pedal module to body
10 Nm