Rabbit L5-2.5L (BGP) (2006)
Headlamp Washer Spray Nozzle: Service and Repair
Lift Cylinder For Washer Jets, Removing and Installing
Lift Cylinder For Washer Jets, Removing And Installing
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove washer nozzles with cover cap -1- up to stop out of bumper cover.
-
Unclip cover cap -1- from bearings -arrows- on spray jet holder.
-
Remove front bumper cover.
-
Pull off securing clip -4- from hose connection.
-
Disconnect hose connection from lift cylinder -2-.
-
Remove screw -1-.
-
Unclip lift cylinder -2- from bracket -3-.
Installing:
Install in reverse order of removal, noting the following:
-
The hose to lift cylinder must be clipped into hose bracket.
-
Tighten all fasteners according to value in table.
-
Bleed headlamp washer system after completing assembly work.