Rabbit L5-2.5L (BGP) (2006)
Wiper Arm: Service and Repair
Aero Windshield Wipers, Removing and Installing
Aero Windshield Wipers, Removing And Installing
Removing:
NOTE:
-
Right and left wiper blades may not be interchanged during installation.
-
Aero-wipers are very flexible. Grasp wiper blades only in area of wiper blade mount to lift them off front windshield.
-
To remove wiper blades, wiper arms must be driven into "service/winter position". The "service/winter position" is activated by operating
windshield wiper lever in "touch sweep" position within 10 seconds after switching off ignition.
-
Drive wiper arms into "service/winter position", do this by operating windshield wiper lever into "touch sweep" position within 10 seconds after
switching off ignition.
-
Fold up wiper arm.
-
Turn wiper blade -1- on wiper arm until it reaches stop -arrow A-.
-
Pull off wiper blade -1- from wiper arm axle -arrow B-.
Installing:
-
Slide wiper blade onto axle of wiper arm.
-
Turn wiper blade on wiper arm axle until it reaches stop.
-
Carefully fold wiper arm back onto windshield.