Rabbit L5-2.5L (CBUA) (2008)
Variable Valve Timing Cover / Housing: Service and Repair
Control Housing Cover
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
^
Torque Wrench V.A.G 1332
^
Hand drill with plastic brush attachment
^
Protective eyewear
^
Silicone sealant D 174 003 A2
Removing
^
Engine removed, transmission disconnected from flange
-
Remove chain case cover.
-
Remove flywheel or drive plate and remove sensor wheel for Engine Speed (RPM) Sensor G28 from crankshaft.
-
Remove cylinder head.
-
Disengage wiring harness - arrow - and remove Engine Speed (RPM) Sensor G28 - 1 - and vacuum pump - 2 -.
-
Remove bolts - 3 -.
-
Press off control housing cover - 1 - from cylinder block - 2 - or from upper section of oil pan - 3 - at the positions designated at top and bottom
using a suitable screwdriver - A -.
-
Start in area of alignment bushings - arrows -.
Note: