Rabbit L5-2.5L (CBUA) (2008)
^
Make sure sealing surfaces are not damaged.
-
Drive out sealing ring with control housing cover removed.
Installing
CAUTION!
To prevent injuries from shavings, wear protective goggles and protective clothing.
-
Remove remainder of sealant from cylinder block, upper section of oil pan and control housing cover e.g. using a rotating plastic brush.
CAUTION!
Make sure that no sealant residue enters the engine.
-
Clean sealing surfaces of cylinder block, upper section of oil pan and control housing cover, they must be free of oil and grease.
-
Replace sealing rings - 1 - and - 2 -.
-
Cut tube nozzle at front marking (diameter of nozzle approximately 1 mm).
Note:
^
The control housing cover must be installed within 5 minutes after application of sealant.