Rabbit L5-2.5L (CBUA) (2008)
Oil Pan: Service and Repair
Oil Pan Lower Section
Oil Pan Lower Section
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
^
Hand drill with plastic brush attachment
^
Protective eyewear
^
Silicone sealant D 174 003 A2
Removing
-
Remove noise insulation.
-
Drain engine oil.
Note:
^
Observe disposal regulations!
-
Remove mounting bolts.
-
Press off lower section of oil pan at lift out pockets provided - arrows - on upper section of oil pan. Be careful not to damage sealing surfaces in
the process.
-
Replace damaged lower section of oil pan.
Installing
CAUTION!
To prevent injuries from shavings, wear protective goggles and protective clothing.
-
Remove remainder of sealant from upper and lower section of oil pan e.g. using a rotating plastic brush.
CAUTION!
Make sure that no sealant residue enters the engine.
-
Clean sealing surfaces so they are completely free of any oil or grease.
-
Cut tube nozzle at front marking (dia. of nozzle approximately 1 mm).
-
Note shelf-life date.