Rabbit L5-2.5L (CBUA) (2008)
Note:
^
The lower section of oil pan must be installed within 5 minutes after application of sealant.
-
With engine removed, apply sealant bead - A - as depicted on to clean sealing surface of upper section of oil pan.
^
The sealant bead must be 1.5 to 2.0 mm thick.
Note:
^
With engine installed, apply sealant in the same manner on to lower section of oil pan.
^
Sealant bead must be routed on inside on holes for bolts.
-
Install all bolts and tighten them in diagonal sequence.
The rest of installation follows reverse of the removal procedures. When doing this note the following:
^
After installing lower section of oil pan, allow sealant to dry for approximately 30 minutes. Only after then may the engine oil be replenished.
Tightening Specifications