Rabbit L5-2.5L (CBUA) (2008)
-
Place Headlamp Beam Adjusting Motor - 1 - in headlamp in position shown in illustration.
-
Raise low beam reflector slightly and pivot positioning motor ball head - 1 - so that it can slide in - direction of arrow - into ball head mount - 2 -.
-
Raise low beam reflector slightly and rotate Headlamp Beam Adjusting Motor - 1 - in - direction of arrow - as far as stop.
-
Install both Headlamp Beam Adjusting Motors bolts and install cover cap.
CAUTION: When installing the cover cap, make sure the cap is properly seated. It is destroyed by ingress of water into headlamp.
-
Seal broken out assembly opening - 1 - with a plug ordered separately
-
Check headlamp for function.
-
Check and adjust headlamp aim if necessary