Rabbit L5-2.5L (CBUA) (2008)
-
Rotate lamp locking device - 1 - in - direction of arrow - and remove lamp locking device.
-
Carefully remove gas-discharge lamp - 1 - from mount.
Installing
CAUTION: When installing the cover cap, make sure the cap is properly seated. It is destroyed by ingress of water into headlamp.
NOTE:
-
Do not touch glass cone when installing gas-discharge lamp. Fingers leave traces of grease on glass cone which can evaporate when gas-discharge
lamp is switched on and glass cone will cloud.
-
Glass cone of gas-discharge lamp must not be under a mechanical strain of any kind. Glass cone is extremely sensitive and is also under high
pressure.
-
Avoid looking directly into focused light beam, since UV radiation of gas-discharge lamp is approximately 2.5 times higher than that of standard
Halogen lamps.
-
If a headlamp with automatic vertical headlamp aim control is removed, basic setting of headlamps must always be performed after installation.
Install in reverse order of removal, noting the following:
-
When installing lamp locking device, ensure gas-discharge lamp is seated correctly in lamp locking device.
-
Check headlamp for function.
-
Check and adjust headlamp aim
High Beam Bulbs
High Beam Bulbs
NOTE: The following illustrations depict replacement of lamp for high beam headlamp at left headlamp.
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.