Rabbit L5-2.5L (CBUA) (2008)
-
Pull off cover cap - 1 -.
-
Disconnect harness connector - arrow -.
-
Press spring retaining wire - 2 - in - direction of arrow - under catches - 1 - and fold spring retaining wire - 2 - upward.
-
Remove high beam headlamp - 1 - from headlamp.
Installing
CAUTION: When installing the cover cap, make sure the cap is properly seated. It is destroyed by ingress of water into headlamp.
NOTE: Do not touch the glass of the light bulb, when installing. Your fingers will leave traces of grease on the glass which, when the lamp is switched
on, will evaporate and cloud the glass.