Rabbit L5-2.5L (CBUA) (2008)
In the Rabbit-GTI handle, the button must not be pressed in.
-
If this should happen anyway, unclip handle trim upward.
-
Press small lever for cable rod -arrow- again into groove before handle is installed.
-
After installing, engage knob again, push plastic part beneath knob downward again.
Handle, Installing
For all knobs there is the possibility to push the button into the knob. Do not install the knob with the button pushed in under any
circumstance.
-
Before removing, pull button past pressure point.
-
Secure button against being pushed in, using cable tie or wire.
-
Unclip cover.