Rabbit L5-2.5L (CBUA) (2008)
Clutch Switch: Service and Repair
Clutch Position Sensor G476, Removing and Installing
Clutch Position Sensor G476, removing and installing - 0A4, 5 Speed M/T
Special tools, testers and auxiliary items required
^
Hose clamps 3094
Removing
-
Check whether a coded radio is installed. In this case, find out anti-theft coding.
-
Disconnect battery Ground (GND) strap with ignition switched off.
-
Remove complete air filter housing, if it is located in the vicinity of the battery.
-
Remove battery and battery carrier.
If a hose/line assembly -1- with a round component is installed directly below the master cylinder, hose/line assembly must be removed.
Note: While performing the following work, make sure that no brake fluid comes into contact with longitudinal member or with transmission. If this
happens, these areas must be cleaned thoroughly.