volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing cover cap (without lock cylinder) > < Removing and installing

Up!

Removing and installing lock cylinder cover cap
Removing and installing lock cylinder cover cap
Removing
  Note
t  When removing lock cylinder cover cap, the screwdriver should not be turned and the screwdriver should not be used as a lever.
t  Lock cylinder and cover cap are only installed on the driver side.
   
–  Pull door handle off door.
–  Push a small screwdriver -3- slightly -arrow a- into opening on underside of lock cylinder cover cap.
–  Pull lock cylinder housing cover cap -1-, together with small screwdriver, off door lightly from underside -arrow b-.
–  Push cover cap upwards off lock cylinder.
Installing
Carry out following work:
  N57-10339
–  Pull door handle -1- off door.
–  Push lock cylinder cover cap -2- at a slight angle from above -arrow a- onto lock cylinder.
–  Push lock cylinder cover cap -2- onto door -arrow b- until cover cap engages in lock cylinder.
  N57-10340

Removing and installing cover cap (without lock cylinder) > < Removing and installing