Volkswagen Workshop Service and Repair Manuals > Up! > Body | General body repairs, interior | Interior equipment | Storage compartments/covers | Removing and installing dash panel cover on driver's side | Removing and installing dash panel cover on driver's side, "High"

Removing and installing dash panel cover on driver's side, „High“

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1783-

Note

For greater clarity, steering wheel is not shown in figure. Its removal is not necessary.

Removing

–	Switch off ignition.

–	Remove side dash panel cover on driver side → Chapter.

–	Press light switch -E1- forwards and turn to right until it is vertical. Withdraw and disconnect cable harness → Electrical system; Rep. gr.96.

–	Release locking lever of steering wheel positioner.

–	Remove middle dash panel trim → Chapter.

–	Remove centre console → Chapter.

–	Remove lower A-pillar trim → Chapter.

–	Unscrew bolts -1- (1.5 Nm).

–	Remove driver's side dash panel cover -2- from dash panel.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

–	Install in reverse order of removal.

Volkswagen Workshop Service and Repair Manuals