Up!
Dismantling and assembling heater and air conditioning unit |
1 - | Air distribution housing |
2 - | Defroster and air distribution flap actuator |
q | Removing and installing → Chapter |
3 - | Fresh/recirculated air flap actuator |
q | Removing and installing → Chapter |
4 - | Seal |
5 - | Air intake housing |
6 - | Fresh/recirculated air flap |
7 - | Upper part of evaporator housing |
8 - | Lower part of evaporator housing |
9 - | Heater and air conditioning unit wiring harness |
10 - | Fresh air blower -V2- |
q | Removing and installing → Chapter |
11 - | Fresh air blower housing |
12 - | Fresh air blower series resistor with overheating fuse -N24- |
q | Removing and installing → Chapter |
13 - | Cover |
q | For dust and pollen filter. |
14 - | Dust and pollen filter |
q | Removing and installing → Chapter |
15 - | Fresh/recirculated air flap cable |
q | Removing and installing → Chapter |
16 - | Evaporator temperature sensor -G308- |
q | Removing and installing → Chapter |
17 - | Flexible shaft for air distribution |
q | Removing and installing → Chapter |
18 - | Flexible shaft for temperature flap |
q | Removing and installing → Chapter |
19 - | Heat exchanger |
q | Removing and installing → Chapter |
20 - | Temperature flap actuator |
q | Removing and installing → Chapter |
21 - | Seal |
q | Note installation position → Fig.. |
22 - | Evaporator |
q | Removing and installing → Chapter |
23 - | Seal |
q | Note installation position → Fig.. |
24 - | Expansion valve |
q | Removing and installing → Chapter |