Volkswagen Workshop Service and Repair Manuals

Renewing anti-roll bar bushes Special tools and workshop equipment required

t  Torque wrench -V.A.G 1331-

t  Torque wrench -V.A.G 1332- Carry out the following work: Removing –  Remove noise insulation → General body repairs, exterior; Rep. gr.66. –  Raise wheel bearing to unladen position → Chapter.

–  Remove bolts -arrows-. –  Pull anti-roll bar clamp off bush. –  Detach bush from anti-roll bar. Installing

–  Insert new bush -1- on anti-roll bar through opening -arrow-.   Note t  Ensure that the outer edge of bush -1- lies against stop -2-. t  Depending on version, the stop -2- can be located on the left or on the right of bush.

–  Secure clamps to subframe -arrows-. –  Install lower noise insulation → General body repairs, exterior; Rep. gr.66.

Specified torques

Bolt	Specified torque
Anti-roll bar to subframe t  Use new bolts.	20 Nm + 90° further