Vanagon F4-1915cc 1.9L (Water Cooled) (1983)
-
Press 1st/2nd synchronizer rings onto gear by hand and measure gap (a) with feeler gauge
^
a = New part 1.3-1.9 mm (0.051-0.075 in)
Wear limit 0.5 mm (0.020 in)
-
Assemble 1st/2nd gear synchronizer
-
Groove (arrow A) must face 2nd gear
-
Collar on hub must face 1st gear
-
Grooves (arrow B) are for identification:
^
1st gear & 2nd gear -- 1 groove
^
3rd gear & 4th gear -- 2 grooves
-
Slide sleeve over synchronizer hub. Matched position is not necessary
-
Insert keys and install springs with ends offset 120°. Angled ends of springs must fit into keys