240 L4-2.3L SOHC VIN 88 B230F (1986)
A17
Press on vibration damper
Use 5294 (front end special tool), small end facing down, to press damper into position.
A18
Check that washer is in place on shaft
NOTE:
This is especially important if washer has been removed and reinstalled. It should not be possible to turn washer.
A19
Assemble gearbox
NOTE:
Aluminum surfaces should be treated with assembly paste prior to installing bearings and shafts.
Part Number:
1161006-0 Aerosol
1161078-9 Tin
NOTE:
Aluminum gearboxes with vibration damper:
Intermediate shaft should have only 0.0-0.05 mm end play. Preload may contribute to stiff gear shifting. Original adjustment shims can be reused.
NOTE:
Original adjustment shims can be reused.
A20
Install gearbox
Fill with oil
A21
Take care not to crossthread drain plugs
Do not overtighten plugs.
Tightening torque: 27-40 N-m (20-30 ft.lbs.). Applies to gearboxes with aluminum or cast iron housing.