1984 Honda 240 L4-2127cc 21L Temperature Gauge Diagrams
Check temperature gauge using 68 ohm resistor (P/N 999 5824-1).
^ Disconnect battery ground lead.
^ Disconnect sensor lead.
^ Connect test resistor across connector terminals.
^ Reconnect battery ground lead and switch on ignition.
-
If instrument is intact, needle should indicate in middle of red zone. (Tolerance: ± width of needle.)
-
If reading is correct, sensor is faulty.
-
If reading is incorrect, instrument is faulty. Replace instrument. See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster /
Carrier/Service and Repair
-
If instrument shows no reading, check wiring.
^ Use ohmmeter to check for wiring open-circuit.
-
If wiring is intact, replace instrument. See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and Repair