240 L4-2127cc 2.1L SOHC B21A (Can) (1984)
Extender Type A or B. (see part number below).
NOTE:
If the car has a single-retractor belt, a dual-retractor seat belt system must be installed according to instructions found on page 338 of Service Manual
TP 31127/1; Body, Interior, Climate.
From 1990 MY (744, Chassis No.397000->, 745 Chassis No.242700->, 764 Chassis No. 76900->, 765 Chassis No. 31200->)and up, use Type D.
780
From 1987 MY, up to and including part of 1990 MY (780 Chassis No.-> 9964), use Extender Type A.
From part of 1990 MY (780 Chassis No.9965->) and up, use Extender Type D.
900
From 1991 and up, use Extender Type D.
850
From 1993 and up, use Extender Type D.
Note: For MY93 850 cars with Chassis Nos. below 44448, where an extender is needed, belt catches must be changed. Pivot type catch P/N 9136184
(driver's side) and P/N 9136185 (passenger's side) must always be used in combination with the extender. New catches will be provided with the
extender if the Chassis No. is below 44448.
S/V40, S/V/C70, S/V90, S80
From 1998 and up, use Extender Type D.
Extender Type A can be used in conjunction with the seat belts shown.
Extender Type B can be used in conjunction with the belts shown.
Extender Type D can be used in conjunction with the seat belts shown.
Extender Type D can also be used in conjunction with all front seat belts in the following models: S/V/C7O, S80, S/V90
Seat Belt P/N Labeling: