240 L4-2127cc 2.1L SOHC Turbo B21FT FI (1982)
- support (A) between body and heater.
- reinstall capillary tube rubber grommet (reseal tube hole with duct tape or butyl tape)
A4
Remove valve and control cable
Heater hoses in engine compartment must be clamped. Clamp hose (A) from heater by applying hose clamp tool beside valve in car.
Undo hose clamps (B) and remove valve (C) with hose. Disconnect cable (D) at control panel (E) and remove cable.
A5
Attach new cable to new valve
Insert:
- wire in hole in valve control arm.
Adjust position of cable in clip (A) so that valve opens fully and closes fully.
Caution:
Control arm is easily broken and must be treated with extreme care.