240 L4-2320cc 2.3L SOHC B23F FI (1983)
Alignment: Technical Service Bulletins
Alignment - Revised Front Camber Specifications
MODEL
GROUP
NUMBER
200
64
122
TITLE
ALIGNMENT SPECIFICATIONS
MARKET
DATE
US and Canada
March 1991
REFERENCE:
TP 30864/6 (ENGLISH); 09/90; SPECIFICATIONS; page 78.
TP 88683/6 (ENGLISH); 11/90; POCKET DATA BOOKLET; page 101.
TP 30000/4 (ENGLISH); 07/87; FRONT WHEEL SUSPENSION; page 1, 8,9.
TP 30001/3 (ENGLISH); 03/83; STEERING; page 2, 8, 9.
New Front Camber Specification
The camber specification listed below should be used for all 200 series cars with power steering. Note that the upper range of the camber has been
increased to +1 degree. However, observe the listed restrictions.
CAMBER
...........................
+ 1/4 to + 1 degree
RESTRICTIONS:
*
The difference between left and right camber should not exceed 1/2 degree.
*
If uneven tire wear, or if "feathering" of the tire is observed, the camber should be set as close to the lower range (+1/4 degree) as possible.
Note:
This specification is considered to be retro-active for all 200 series cars. Thus this specification amends specifications stated in the
above-referenced manuals.
Cars that have been set up to the previous specification, and remain within the previous specification, need NOT be re-adjusted to the new specification.
