240 L6-2383cc 2.4L DSL SOHC D24 FI (1982)
5. To Adjust:
-
Engage position D.
-
Unscrew bolts (arrows).
-
Adjust switch so that P is opposite lever (A).
-
Engage position N and check that N mark is opposite (A).
-
Move selector lever forward and back, through gears (P to 1) and check that pin (B) does not slide out of lever (A).
-
Check that engine can only be started in positions P and N and that reversing (back-up) lights come on in position R.
-
If reversing (back-up) light flashes when vehicle is reversed, move switch contact 1 mm (0.04 in) forward. After adjustment make sure that
vehicle can only be started in "P" and "N".
-
Check that gear selector panel light works and is correctly installed. Install cover for selector linkage.