240 L6-2383cc 2.4L DSL SOHC D24 FI (1982)
Rear Housing
Use drift P/N 2412 to install bearing in rear housing.
New Output Shaft
CAUTION:
^
During the 1979 Model production run, a new output shaft and thrust washer were introduced.
^
To hold the thrust washer between the one-way clutch and output shaft better in position:
-
thrust washer thickness was increased from 2.5 mm to 3.8 mm.
-
the shaft groove depth was increased from 1.9 mm to 3.2 mm.
^
The new thrust washer 1232644-3 is used with the new output shaft 1232646-8.
^
The old thrust washer 380715-3 is used with the previous type output shafts 380679-1 and 1232105-5.