240 L6-2383cc 2.4L DSL SOHC D24 FI (1982)
Apply butyl tape as shown in the diagram.
The butyl must be located around the entire upper edge of the windshield approx. 200 mm (7 3/4") down the A post.
Note
The butyl tape helps prevent wind noise.
Before installing the trim strip the FUR adhesive must have cured for approx. 10 minutes. Install the trim strip, use white petroleum jelly.
Note
The car must not be used for four hours after the windshield has been installed.
Note
If the car is equipped with a SRS-system then a decal (P/N 3517690-8) is available.
