740 L4-2.3L SOHC VIN 88 B230F (1985)
Connect adapter 5175 to hydraulic pump.
NOTE:
Use 5/8 - 18 UNF banjo-bolt (P/N 948490-8) and two washers, P/N 11996-6.
Connect adapter 5320 to tube connected to hose. Lift tube as far as possible in engine compartment.
Place the pressure gauge in a suitable position where it can be seen from the driver's seat.
Fill reservoir with oil
Specified oil:
ATF type A, F or G
Top-up almost to edge of reservoir.
To prevent damage to the pump:
Bleed the hydraulic system by turning the steering wheel from lock to lock before starting the engine. Start engine and leave it idling. Turn the steering
wheel between locks. Top-up with oil as the level drops. Continue until the oil level does not drop any more. Turn engine OFF.
Remove steering wheel impact pad (arrow)