740 L4-2.3L SOHC VIN 88 B230F (1985)
Overdrive Unit, M/T: Service and Repair
Hydraulic Pistons Replacement
1. Remove overdrive unit from vehicle.
2. Tool P/N 2709 must be modified if it will be used on a three-pin carrier. To modify the tool, drill out the two existing holes on the tool to 16 mm
(as shown in the illustration).
3. Remove gasket and pressure plate assembly.
4. Using pliers, remove hydraulic pistons.
5. Install new hydraulic pistons and O-rings.
6. Install pressure plates, using new nuts. Torque nuts alternately and evenly to 10 Nm (7.5 ft lb).
7. Install overdrive unit.