740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
-
Fix upper length of cable with a cable clip or clamp between tilt support and upholstery. This is to prevent noise caused by cable striking
against upholstery and trim.
Reassembly
-
Replace plastic holder for tilt support.
-
Attach elastic retainers inside trim (if they were slackened oft).
Replacing trim
-
Pull down trim and allach.
-
Use new clips.
Replacement of seatback
-
Replace seatback on seat.
-
Replace the four screws: Tighten the two front screws, M10, to tightening torque 50 Nm (37 ft.lb). Tighten the two lower screws, M8, to
tightening torque 30 Nm (22 ft.lb).
Replacement
Models to 1994:
-
Pull down control panel and fix screw in rear edge.
-
Replace battery negative lead.
1995 models:
-
Replace control panel. See: Service and Repair/Control Panel For Power Seat, Change
-
Replace battery negative lead.